I guess I messed up during the drying process. Such a beautiful cola, too, but I forgot to take a pic before I noticed the mold - at which point I just started peeling away chunks at a time ☹️

What a bummer.

  • <sub></sub>@leminal.spaceOPEnglish
    4·
    20 hours ago

    I guess because I was trying that “hang the whole branch to dry” method, with the same arrangement I had with the larfy harvest before it. I needed to increase airflow, I think? I dunno, but I think I’ll stick with taking everything off the strm for now

    • SchmidtGenetics@lemmy.world
      3·
      20 hours ago

      What were your conditions? You should keep the air moving at all times.

      Where I am it’s stupid dry, so I have to leave stuff on the branches or it’s over dry in days.

      • <sub></sub>@leminal.spaceOPEnglish
        2·
        13 hours ago

        It was towars the upper edn of 50% humidity , and I had air moving around the room, but not specifically for this purpose ans I think with the level of humidity I should have had a fan or dehu going. I think it might work well when the weather is actually more wintery than it is now, but until then I have to be more diligent

        • SchmidtGenetics@lemmy.world
          2·
          12 hours ago

          Huh.

          I usually set my exhaust fan to turn on at 60%rh and my humidifier (if I use it) to turn off at 55%rh. I keep my upper and lower canopy fans going 100%, but you want the RH to be up, but that’s why you want LOTS of indirect airflow.

          You want a sealed climate, so a grow tent or you can rig up a tote if it’s a small enough batch or something.

        • Ey ich frag doch nur@lemmy.world
          1·
          41 minutes ago

          I’d guess that there was already mold in the bud at harvest. It looks like a lot and I think it takes a few days for mold to spread that much.

    • ContrarianTrail@lemm.eeEnglish
      3·
      20 hours ago

      You mean the entire plant or individual branches with the fan leaves removed? Because the latter should be fine as long as there’s some air circulation and the relative humidity isn’t too high. That’s how I’ve always dried them and I’ve never had mold. Few times I’ve moved them drying elsewhere after the surface has still felt moist after like 4 days of drying.

      • <sub></sub>@leminal.spaceOPEnglish
        2·
        13 hours ago

        I removed the fan leaves, and even did most of a wet trim. I think I didn’t have as much air circulation in the part of the basement this was hung in as i did the other spot. It was just one main stem with 2 separate and smaller branches. Nothing fancy over here until I can make one that comes out right from start to finish